Model No.: SD01065230
Packaging: Wooden Case
Productivity: 100 Thousands Annual
Place of Origin: Xinxiang
Supply Ability: 100 Thousands Annual
Certificate: ISO 9001, ISO 14001, ASME, OHS
HS Code: 8421299090
Flow m³/min/0.7MPa: 5.5
Flange Fiameter: 200
The Oil-Gas Separators are usually composed of different layers. The first layer is usually a coalescing layer made of glass fiber with a certain thickness and porosity. The multi-layer sub-micron glass fiber ensures efficient capture of different lubricating oil drops at higher temperatures. The second layer is a separation layer, and the coalesced large oil droplets are diverted through the separation layer into the bottom container.
Install sealing correctly and check whether there is a conductive measure;
Return pipe must be long enough and put straight into the filter, the end should be beveled, pay attention to check blockage;
I. the high oil content of the exhaust.
1. Return line blockage.
2. Gaskets used improperly resulting in oil core short circuit.
3. Oil Separator tank design or selection unreasonable.
4. Oil barrel oil level is too high.
5. Compressor Low pressure operation, the displacement increases, reduced Separation Filter.
6. Operating temperature is too high, increase the amount of lubricating oil evaporation.
7. Use of substandard lubricants.
Under the rated flow rate and working pressure, outlet oil content: 0.1-3 mg/m³.
Note: The oil-gas separation filter can only achieve physical filtration, unable to capture the oil vapors in compressed gas; the above outlet oil content refers to the content of the non-gaseous oil aerosols. To get higher quality compressed air, after-filter is required.
Filter life consumption mainly shows in the form of the flow resistance increasing, so the service life is the primarily related to oil cleanness and filter properties. As long as the system is functioning properly, the service life can be up to 8000 hours(365 days no shut down), but no more than 10000 hours, the glass fiber falling down into the lubrication system causing secondary pollution should be prevented.
Flow resistance is an important indicator of filter performance. Under the premise of guaranteed filtration performance, lower flow resistance can reduce compressor energy consumption. Through several tests and improvement, the initial oil saturation pressure drop of oil-gas separation filter is within 16kpa, lower than the standard value 20kpa of peers.